News: Both repeaters are on the air!

Author Topic: How to Install Android IAX  (Read 2074 times)

Offline loren

  • Owner
  • Administrator
  • Newbie
  • *****
  • Posts: 38
  • Karma: +1/-1
  • Gender: Female
  • Greetings!
How to Install Android IAX
« on: October 27, 2015, 03:43:05 PM »
Firs you will need to go to this page with your android phone and download this program and run it.. Your phone will need to be put into developer mode in order for this program to work most phones will let you put it into development mode by ..

Here's how to get them back:
Go to the settings menu, and scroll down to "About phone." Tap it.
Scroll down to the bottom again, where you see "Build number." (Your build number may vary from ours here.)
Tap it seven (7) times.

If you have problems getting your phone into development mode contact your Wireless Service provider they will have more details about your phone.

Here is Android Download for Android IAX

Here is a some what image that it looks like

To setup your iax accounts you will need to go to screen that looks like this.

Hope this helps out with the installation of the software.

Below is how to get the software to talk to your node.

In extensions.conf

At the top of the file make sure that it looks similar to this

static=yes       ; These two lines prevent the command-line interface
writeprotect=yes ; from overwriting the config file. Leave them here.

Code: [Select]

Now under custom configs put this in extensions.conf
Code: [Select]
[iax-client] ; for IAX VIOP clients
exten => ${NODENUMBER},1,Ringing
exten => ${NODENUMBER},n,Wait(3)
exten => ${NODENUMBER},n,Answer
exten => ${NODENUMBER},n,Set(NODENUM=${CALLERID(number)})
exten => ${NODENUMBER},n,Playback(rpt/node|noanswer)
exten => ${NODENUMBER},n,SayDigits(${EXTEN})
exten => ${NODENUMBER},n,Set(CALLERID(num)=0)
exten => ${NODENUMBER},n,Rpt,${NODENUMBER}|P|${CALLERID(name)}
exten => ${NODENUMBER},n,Hangup
exten => ${NODENUMBER},n(hangit),Answer
exten => ${NODENUMBER},n(hangit),Wait(1)
exten => ${NODENUMBER},n(hangit),Hangup

Now to iax.conf

Under Custom put this..
Code: [Select]
[UsernameYOUwishtouse]                    ; Connect from iax client (Zoiper...)
type=friend                  ; Notice type here is friend <--------------
context=iax-client            ; Context to jump to in extensions.conf
« Last Edit: June 27, 2016, 01:37:48 AM by kc9zhv »